EFFECT OF AIR MASS FLOW RATE ON THE PERFORMANCE OF AN EARTH AIR HEAT EXCHANGER USED IN COOLING THE ELECTRIC MOTOR OF AN OIL PUMP: A NUMERICAL INVESTIGATION
DOI:
https://doi.org/10.30572/2018/KJE/170433Keywords:
Cooling, Electric Motor, Earth's Temperature, NTU, Numerical InvestigationAbstract
Elevated temperatures in electric motors significantly contribute to diminished efficiency and a reduced lifespan. An EAHE can be utilized as an efficient cooling method to lessen this issue. This study designed a theoretical model of a 3-phase, squirrel-cage induction motor using ANSYS 2024/FLUENT software. The motor was connected to an underground pipe 4 m deep. This research numerically investigated several design parameters, including the effect of air mass flow rate, pipe diameter, outlet condition, and required cooling load. The study utilized 90 m of PVC (polyvinyl chloride) earth-air heat exchanger (EAHE) pipes with an inlet temperature of 50°C, based on the climatic conditions of Nasiriyah, southern Iraq. The results showed that raising the air mass flow rate reduces the electric motor temperature. The observed reduction in the maximum motor temperature was approximately 11.00%, 11.51%, and 11.85% for pipe diameters of 6, 4, and 3 in, respectively. This shows that the smaller the diameter, the greater the ratio of reduction, and this results in increased system efficiency. An EAHE is effective in its use, bringing the electric motor temperature down, which leads its performance to an increase in efficiency and increases its life
Downloads
References
Al-Ajmi, F., Loveday, D.L. and Hanby, V.I. (2002) ‘Thermal performance of the sub-soil environment in dry desert climate’, ASHRAE Transactions, 108(Pt. 2).
Al-Ajmi, F., Loveday, D.L. and Hanby, V.I. (2006) ‘The cooling potential of earth – air heat exchangers for domestic buildings in a desert climate’, 41, pp. 235–244. Available at: https://doi.org/10.1016/j.buildenv.2005.01.027.
Alikhan, A.H.D. Mery, H.O. Sadiq, S.E. and Mohammed, O.M. (2025) ‘THE INFLUENCE OF PLATE CONFIGURATION AND CUO NANOFLUIDS ON HEAT TRANSFER AND PRESSURE’, Kufa Journal of Engineering 16(3), pp. 624–638. Available at: https://doi.org/10.30572/2018/KJE/160335.
Greco, A. and Masselli, C. (2020) ‘The Optimization of the Thermal Performances of an Earth to Air Heat Exchanger for an Air Conditioning System : A Numerical Study’. Energies 13.23, 6414. Available at: https://doi.org/10.3390/en13236414.
Hammadi, S.H. and Mohammed, A.H. (2014) ‘Application of Earth Tube Heat Exchanger and Solar Chimney for Natural Cooling System in Basrah City’, Journal for Engineering Sciences,41, pp 23-32.
Hannun, R.M., Hammadi, S.H. and Khalaf, M.H. (2019) ‘HEAT TRANSFER ENHANCEMENT FROM POWER TRANSFORMER by’, Thermal Science 23(6), pp. 3591–3602. Available at: https://doi.org/10.2298/TSCI171231116H.
Hanoon, M.A., Fagr, M.H. and Mekki, K.S. (2025). ‘ENHANCEMENT OF HEAT TRANSFER NUMERICALLY BY’, Kufa Journal of Engineering, 16(3), pp. 1–21. Available at: https://doi.org/10.30572/2018/KJE/160301.
Hasan, M.I. (2011) ‘Influence of wall axial heat conduction on the forced convection heat transfer in rectangular channels’, Basrah Journal for Engineering Science, 1, pp. 31–43.
Hasan, M.I. and Muter, D.M. (2021) ‘Numerical Investigation of the Air Flow Rate Effect Performance of Earth to Air Heat Exchanger Used for Cooling of Poultry Houses’, Journal of Advanced Research in Fluid Mechanics and Thermal Sciences 84.2, 2(2), pp. 167–184. Available at: https://doi.org/10.37934/arfmts.84.2.167184.
Hasan, M.I. and Noori, S.W. (2018) ‘Numerical investigation of earth to air heat exchanger for cooling and heating applications under undisturbed soil conditions’. Journal of Engineering and Sustainable Development, 22(2), pp. 10–29. Available at: https://doi.org/10.31272/jeasd.2018.2.2.
Hasan, M.I. and Shkarah, A.J. (2019) ‘Parametric study on the performance of the earth ‐ to ‐ air heat exchanger for cooling and heating applications’, (March). Available at: https://doi.org/10.1002/htj.21458.
Hummood, E.A. & Hasan, M.I., 2024. Experimental investigation of using the geothermal energy for cooling of air supply instruments in oil fields. International Journal of Applied Engineering & Technology, 6(1), pp.230-249. Available at: https://romanpub.com/resources/ijaet20v6-1-2024-27.pdf.
Jalghaf, H.K. and Hatem, F.F. (2017) ‘EXPERIMENTAL AND NUMERICAL INVESTIGATION OF SLOT DIMPLE TUBE ON THE HEAT EXCHANGER’, Kufa Journal of Engineering, 8(3), pp. 1–20.
Kurnia, J.C. Shatri, M.S. Putra, Z.A. Zaini, J. Caesarendra, W. and Sasmito, A.P.(2021) ‘Geothermal energy extraction using abandoned oil and gas wells : Techno-economic and policy review’, (December 2020), pp. 1–33. Available at: https://doi.org/10.1002/er.6386.
Kusuda, T., Piet, O.T. and Bean, J.W. (1983) Annual variation of temperature field and heat transfer under heated ground surfaces: slab-on-grade floor heat loss calculation. Washington, DC: Building Science Services, USA.
Labs, K. and Cook, J. (1989) Passive cooling. Cambridge, MA: MIT Press, London, England
Launder, B.E. and Spalding, D.B. (1974) ‘The numerical computation of turbulent flow’, Computer Methods in Applied Mechanics and Engineering, 3(2), pp. 269–289.
Madhavan, S. Devdatta P B, R. Konda, Y.R, Gundabattini, E. Mystkowski,A. Palka ,R. Wardach, M. and Prajzendanc, P. (2023) ‘Thermal management analyses of induction motor through the combination of air-cooling and an integrated water-cooling system’, Scientific Reports, 13(1). Available at: https://doi.org/10.1038/s41598-023-36989-2.
Moreland, F.L., Higgs, F. and Shih, J. (eds.) (1980) Earth-Covered Buildings: Proceedings of the Conference, Fort Worth, Texas, USA, May 1978. Washington, DC: U.S. Department of Energy; MD: National Bureau of Standards, 1983.
Nasr, A.R., Badran, E.A. and Mansy, I.I.I. (2025) ‘A Novel Cooling Technique to Improve the Thermal Characteristics of a Permanent Magnet Generator Using an Earth – Air Heat Exchanger’, 2025. Available at: https://doi.org/10.1155/jece/9987298.
Pandharpur, C. Ronge, D. Kadam, V. Shende, S. and Kate, P. (2020) ‘Design of an Earth Air Heat Exchanger System for Space Cooling in Hot and Dry Design of an Earth Air Heat Exchanger System for Space Cooling in Hot and Dry Climate of Pandharpur, India’, (July). Available at: https://doi.org/16.10089.AJ.2020.V8I6.285311.3684.
Qi, D. Li, A. Li, S. and Zhao, O. (2020) ‘Comparative Analysis of Earth to Air Heat Exchanger’. Available at: https://doi.org/10.1016/j.applthermaleng.2020.116152.
Rosa, N. Soares, N. Costa, J. J. Santos, P. and Gervasio, H. (2020) ‘Assessment of an earth-air heat exchanger ( EAHE ) system for residential buildings in warm-summer Mediterranean climate’, Sustainable Energy Technologies and Assessments, 38(November 2019), p. 100649. Available at: https://doi.org/10.1016/j.seta.2020.100649.
Sakhri, N., Menni, Y. and Ameur, H. (2020) ‘Effect of the pipe material and burying depth on the thermal efficiency of earth-to-air heat exchangers’, Case Studies in Chemical and Environmental Engineering, p. 100013. Available at: https://doi.org/10.1016/j.cscee.2020.100013.
Soltani, M.; Kashkooli, F.M.; Dehghani-Sanij, A.R.; Kazemi, A.R.; Bordbar, N.; Farshchi, M.J.; Elmi, M.; Gharali, K. and Dusseault, M.B.(2018) ‘SC’, Sustainable Cities and Society [Preprint]. Available at: https://doi.org/10.1016/j.scs.2018.09.036.
Downloads
Published
Issue
Section
Categories
License
Copyright (c) 2026 Baraa A. Gaber, Rafid M. Hannun

This work is licensed under a Creative Commons Attribution 4.0 International License.












